Sunday, 4 April 2010

Roof Flue Ring & Laminate Floor

This is the spacer ring I have made to facilitate the fitting of the water heater flue.  In the earlier blog I made the disks.  Then I cut the hole out shaped them to up, and dressed the edge with a thin off cut of GRP sheet.

I didn't want to get into a session today, just have a potter so I laid the laminate flooring to the storage area floor under what will be the bed.

 £9.98 well spent

I also had a good tidy up which required a trip to the dump.  In the end I took a car load of stuff.  Where does it all come from?

No comments:

Post a Comment